A Step-By-Step Guide…
Step 1: Slide the ferrule over the co-ax
Step 2: Using the utility knife remove the outer
sheath from the co-ax 20mm from the end. (Careful
not to cut through the wire braid underneath).
Step 3: Discard the waste to reveal the prepared
co-ax and fold back the outer wire braid.
Step 4: Using the utility knife remove the inner
sheath covering the centre core leaving 3mm.
(Careful not to cut the centre core, discard waste).
Step 5: Using the side cutters trim the
centre core leaving 7mm.
Step 6: Insert the centre core into the BNC
until the BNC is flush with the inner sheath.
Step 7: Fold back the braid over the BNC and
trim off any excess, slide the ferrule
over the BNC.
Step 8: Place the wide part of the ferrule & BNC
body into the correct slot (.319”) on the crimp tool.
Step 9: Squeeze the crimp tool until the mechanism releases.
Step 10: Place the narrow part of the ferrule
into the correct slot (.256”) on the crimp tool.
Step 11: Holding the co-ax, squeeze the
crimp tool until the mechanism releases.