A Step-By-Step Guide…

Step 1: Slide the ferrule over the co-ax

---

Step 2: Attach the cable stripper (the cable end

should be flush to the edge of the stripper and

in the correct orientation as per the diagram on

the stripper above).

 

---

Step 3: Rotate the cable stripper 2-3 times in the

direction indicated on the cable stripper.

 

---

Step 4: Remove the cable stripper from the co-ax

and discard the waste to reveal the prepared co-ax.

 

---

Step 5: Fold back the outer wire braid

and slide on the centre pin.

 

---

Step 6: With the centre pin on the co-ax place in

the correct slot (.068”) on the crimp tool.

 

---

Step 7: Holding the co-ax, squeeze the crimp tool

until the mechanism releases.

 

---

Step 8: Slide the BNC body over the centre pin,

a click should be felt.

 

---

Step 9: Move the wire braid & ferrule into position

over the BNC body.

 

---

Step 10: Place the ferrule & BNC body into the

correct slot (.256”) on the crimp tool.

 

---

Step 11: Holding the co-ax, squeeze the crimp tool

until the mechanism releases.

 

---

 

Step 12: Done! You have crimped a 3pc BNC